We use cookies to improve your experience on this website. Read More Ok

Product Image Search

Panel Heaters

In these custom built infrared heaters, the heating coils are embedded in a special ceramic fibre-board which insulates, adds durability and shock resistance. They are a neat, easily mounted and readily expanded heating solution.

Infrared panel heaters are custom built infrared heaters operating primarily in the long wave range. The basic construction consists of a resistance coil embedded into a ceramic fibre board which is then located behind an emitting surface of either anodised aluminium or glass ceramic. This is then placed inside a 75mm high aluminised steel housing which normally contains 50mm of thermal insulation to reduce heat loss through the rear of the unit.

Custom Infrared Panel Heaters

Panel heaters can be used in thermoforming ovens and for various curing and drying applications. The panel heater design and construction makes it a very robust and efficient infrared heater with operating life often in excess of 20,000 hours in many applications (depending on operating temperature and environment). Standard power density is 1.5-2.3 W/cm² (10-15 W/in²). Higher power densities available on request.

Standard options

  • Emitting surface

    • Glass ceramic face - very good radiant efficiency, high percentage transmission of radiant output in medium to short wave range, surface can be easily cleaned.
    • Anodised aluminium face - good radiant efficiency, very robust, surface sheet can be easily cleaned or replaced if damaged by molten material.
  • Electrical terminations
    • Open 2P terminal block
    • Terminal block with cover
    • M6 or 1/4" threaded stud
  • Type K thermocouple with fixed high temperature socket and removable plug
  • Fixing studs: M5/M6/M8/0.25" x 25mm long

Other options available on request. Please contact us for further details.

See also - Infrared Heating Panel Replacement

Technical Information

If you would to place an order or require a quotation for an infrared panel heater, please supply the following information:

  1. Overall dimensions required (length and width)
  2. Wattage required and supply voltage
  3. Zoning requirements (if more than 1 zone required)
  4. Emitting surface type (see above)
  5. Electrical termination type (see above)
  6. With or without thermocouple type K
  7. Fixing studs (see above)
  8. Quantity required
© 2019 Ceramicx | Web Development by Granite Digital